Back
BIAS TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (Cont'd)
Up
Bead Locks
Next
BIAS TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE(Cont'd)
8-4.1. BIAS TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (Cont'd) b.  Inspection and Cleaning .WARNING. Do not reuse a tire which has been run flat without thoroughly inspecting for damage. Failure to follow these instructions may result in injury to personnel or damage to equipment. 1. Inspect inside of tire (1) for cord or belt separation, and inner liner damage. Replace tire (1) if damaged. 2. Inspect tire bead (12) for abrasions caused from runflat (2). Replace tire (1) if damaged. 3. Check for protruding objects inside tire (1) which may not be visible from outside. Repair tire (1) if damaged. 4. Check tread depth on tire (1). Tread should not be worn below level of wear bars (13). Replace tire (1) if tread is worn below wear bars (13) or 3/32 in. (2.38 mm). 5. Inspect runflat spacer (11) for splitting, wear, or excessive chafing. Replace runflat spacer (11) if damaged. 6. Inspect runflat (2) for splitting, wear, or excessive chafing. Replace runflat (2) if damaged. TM 9-2320-280-20-2 Change 2 8-14.5

 


 

Please feel free to link to this site so that others can find it.  It's easy to link to this site, just copy one of the texts below onto your web page:

 

 

Zen's Bronco

 

 

 

 

Copyright 2000-2005