Back
BIAS TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (Cont'd)		 Up
Bead Locks		 Next
BIAS TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (Cont'd)
8-4.1. BIAS TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (Cont'd) 9. Lay tire (1) flat. .WARNING. Do not use runflat compressor if compressor strap is frayed or damaged. Inspect the tool’s pivot points and bearings and ensure runflat is free of grease and runflat compressor strap is centered around runflat. Failure to do so could cause injury to personnel. NOTE • Perform steps 10 and 11 when using runflat compressor P/N J39250. •  Perform steps 12 and 13 when using runflat compressor P/N 528236. 10. Position runflat compressor (3) on runflat (2) so that runflat compressor hex drive (4) is facing up and strap (5) is centered around runflat (2). NOTE Compress runflat by rotating hex drive in either direction. Rotate hex drive opposite to loosen. 11. Using runflat compressor (3), compress runflat (2). 12. Position runflat compressor (6) on an outer edge of runflat (2) with handle assembly (7) facing up and strap (8) centered around runflat (2). NOTE Compress runflat by rotating the handle assembly in a clockwise direction. Rotate handle assembly counterclockwise to loosen. 13. Using runflat compressor (6), compress runflat (2). NOTE •  It may be necessary to use a tire spoon and tire soap to remove runflat from tire. •  When using runflat compressor P/N 528236, handle may need to be removed before removing runflat. 14. Remove runflat (2) from tire (1) and remove runflat compressor (3) or (6) from runflat (2). 15. Remove two lubricant packets (9) and adhesive tape (10) from runflat (2) if installed. Discard lubricant packets (9) and adhesive tape (10). TM 9-2320-280-20-2 8-14.4 Change 2

 

 

Please feel free to link to this site so that others can find it.  It's easy to link to this site, just copy one of the texts below onto your web page:

 

 

Zen's Bronco

 

 

 

 

Copyright © 2000-2005