Next
RADIAL TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (M1123 AND
“A2” VEHICLES) (Cont’d)
NOTEThe radial tire is a bidirectional tire and the tread may bepositioned in either direction.5.Stand tire (1) up and lubricate tire bead (4) with tire soap.NOTEIt may be necessary to remove the handle assembly on runflatcompressor (P/N 528236) before inserting runflat into tire.6.Insert runflat (3), compressor side first, as far as possible into tire (1).7.Lay tire (1) flat on protruding runflat side. Loosen compressor (5). Runflat (3) should insert itselfinside tire (1). If not, repeat steps 5 through 7 and/or use a tire spoon to assist in installation.NOTEIf required, clean and lubricate bearing assembly on runflatcompressor P/N 528236 after removal.8.Loosen runflat compressor (5) and remove from tire (1).WARNINGNever install radial tire on eight bolt wheel. Damage to equipmentmay result causing injury to personnel.NOTEBefore installing tire on inner rim half, inspect tire sidewalls for apaint dot. Paint dots are often painted on tires to indicate the tireslight spot, for balancing purposes. If paint dot is present, position tireon rim halves so that paint dot is aligned with insert hole on outer rimhalf.9.Lubricate tire bead (4) and rim bead seat areas with tire soap.10.Center runflat (3) in tire (1). Carefully lower tire (1) over inner rim half (9).11.Ensure runflat (3) is not binding on flat portion of inner rim half (9). Runflat (3) should clear innerrim half (9).TM 9-2320-280-20-28-24.8Change 28-5.1. RADIAL TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (M1123 ANDA2 VEHICLES) (Contd)
Please feel free to link to this site so that others can find it. It's easy to link to this site, just copy one of the texts below onto your web page: