Next
RADIAL TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (ALL EXCEPT M1123 AND
“A2” VEHICLES) (Cont’d)
NOTEThe radial tire is a bidirectional tire and the tread may bepositioned in either direction.5.Stand tire (1) up and lubricate tire bead (3) with tire soap.NOTEIt may be necessary to remove the handle assembly on runflatcompressor (P/N 528236) before inserting runflat into tire.6.Insert runflat (2), compressor side first, as far as possible into tire (1).7.Lay tire (1) flat on protruding runflat side. Loosen compressor (4). Runflat (2) should insert itselfinside tire (1). If not, repeat steps 5 through 7 and/or use a tire spoon to assist in installation.NOTEIf required, clean and lubricate bearing assembly on runflatcompressor P/N 528236 after removal.8.Loosen runflat compressor (4) and remove from tire (1).9.Apply one 11-ounce tube of gel lubricant (6) around inside of tire (1) at crown area (7).10.Evenly spread gel lubricant (6) 4-5 in. (10-13 cm) wide on tire crown (7).NOTE Ensure longer lip of runflat faces inner rim of tire. Ensure square cut edge of runflat spacer butts up against flatside of runflat.11.Install runflat spacer (5) inside tire (1) and position on valve side of tire (1).12.Lubricate O-ring seal (10) with tire soap. Install O-ring (10) in groove (11.1) on top of inner rim (11),around studs (12). Ensure O-ring is not twisted and that it is uniformly positioned in groove (11.1).Do not overstretch O-ring (10).13.Lubricate tire bead (3) and rim bead seat areas with tire soap.TM 9-2320-280-20-28-22Change 28-5. RADIAL TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (ALL EXCEPT M1123AND A2 VEHICLES) (Contd)4-5 in. (10-13 cm)
Please feel free to link to this site so that others can find it. It's easy to link to this site, just copy one of the texts below onto your web page: