Back
RADIAL TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (ALL EXCEPT M1123 AND “A2”  VEHICLES)		 Up
Bead Locks		 Next
RADIAL TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (ALL EXCEPT M1123 AND “A2” VEHICLES) (Cont’d)
WARNING Never inflate a wheel assembly with the wheel locknuts removed in an attempt to separate inner and outer rim halves. The assembly will separate under pressure resulting in serious injury or death. 4. Remove outer rim half (1) from tire (6). NOTE Perform steps 5 and 6 only if damage to valve bore, insert, or O-ring is evident. 5. Remove valve bore (9) from insert (10). Remove insert (10) and locknut (12) from outer rim (1). Discard locknut (12). 6. Remove O-ring (11) from insert (10). Discard O-ring (11). 7. Remove O-ring seal (5) from inner rim half (4). Cut O-ring seal (5) in two, to make sure it cannot be reused. Discard O-ring seal (5). 8. Remove tire (6) from inner rim half (4). 9. Remove balance weights (3) from rim halves (1) and (4), if present. Discard balance weights (3). 10. Remove runflat spacer (7) from tire (6). TM 9-2320-280-20-2 Change 2 8-17 8-5.   RADIAL TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (ALL EXCEPT M1123 AND “A2”  VEHICLES) (Cont’d)

 

 

Please feel free to link to this site so that others can find it.  It's easy to link to this site, just copy one of the texts below onto your web page:

 

 

Zen's Bronco

 

 

 

 

Copyright © 2000-2005