8-4.1. BIAS TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (Cont'd) 19. Tighten locknuts (2) to 55 lb-ft (75 N•m) in tightening sequence shown. 20. Tighten locknuts (2) to 65 lb-ft (88 N•m) in tightening sequence shown. 21. Check wheel assembly for gaps at each stud (10). Use a 0.0015 in. (0.038 mm) thickness gauge to detect gaps. If gaps are detected, disassemble and reassemble wheel assembly and recheck for gaps. If gaps are still detected, replace outer rim half (5). .WARNING. •  Never inflate a wheel assembly without having checked wheel locknut torques to ensure the wheel locknuts are tightened to specifications. An assembly with improperly tightened locknuts could separate under pressure, resulting in serious injury or death. •  Always use a tire inflation cage for inflation purposes. Stand on one side of the cage, during inflation, never directly in front. Keep hands out of the cage during inflation. Inflate assembly to recommended pressure, using a clip-on air chuck. Do not exceed 50 psi (345 kPa) cold inflation pressure. Failure to follow these instructions may result in serious injury or death. 22. Place assembly in safety cage and inflate tire to recommended tire pressure (TM 9-2320-280-10). 23. Check for leaks around rim edges (11), valve core (3), and valve stem (4) with soapy solution. TM 9-2320-280-20-2 Change 2 8-15 FOLLOW-ON TASK:  Balance tire (para. 8-9).

Please feel free to link to this site so that others can find it.  It's easy to link to this site, just copy one of the texts below onto your web page:

Zen's Bronco

<a href="http://bronco.zenseeker.net/">Zen's Bronco</a>

Copyright © 2000-2005