Back
BIAS TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE(Cont'd)		 Up
Bead Locks		 Next
BIAS TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE(Cont'd)
8-4.1. BIAS TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (Cont'd) d.  Assembly .WARNING. •  Never use tubes in wheel assemblies. Use of a tube defeats built-in safety features, and could allow the wheel to come apart under pressure, resulting in serious injury or death. •  Use only replacement parts specified in TM 9-2320-280-24P. Wheels assembled with components which do not meet specifications could cause the assembly to separate under pressure, resulting in serious injury or death. •  Do not use runflat compressor if compressor strap is frayed or damaged. Ensure runflat is free of grease and runflat compressor strap is centered on runflat. Failure to do so could cause injury to personnel. •  Any oil on runflat compressor belt could result in personnel injury or damage to equipment. Wipe any oil off from belt or handle. NOTE Perform steps 1 and 2 when using runflat compressor P/N J39250. Perform steps 3 and 4 when using runflat compressor P/N 528236. 1. Position runflat compressor (9) on runflat (8) so that runflat compressor hex drive (10) is facing up and strap (11) is centered around runflat (8). NOTE Compress runflat by rotating hex drive in either direction. Rotate hex drive opposite to loosen. 2. Using runflat compressor (9), compress runflat (8). 3. Position runflat compressor (12) on an outer edge of runflat (8) with handle assembly (13) facing up and  strap (14) centered around runflat (8). NOTE Compress runflat by rotating the handle assembly in a clockwise direction. Rotate handle assembly counterclockwise to loosen. 4. Using runflat compressor (12), compress runflat (8). TM 9-2320-280-20-2 Change 2 8-14.7

 

 

Please feel free to link to this site so that others can find it.  It's easy to link to this site, just copy one of the texts below onto your web page:

 

 

Zen's Bronco

 

 

 

 

Copyright © 2000-2005