Back
6-11. STEERING   KNUCKLE   AND   ARM   MAINTENANCE   (ALL   EXCEPT   M1009) (Con’t)		 Up
Axles		 Next
6-11. STEERING   KNUCKLE   AND   ARM   MAINTENANCE   (ALL   EXCEPT   M1009) (Con’t)
TM   9-2320-289-34 6-11. STEERING   KNUCKLE   AND   ARM   MAINTENANCE   (ALL   EXCEPT   M1009) (Con’t). 6 . Remove  seal  (14)  and  bearing  (13).  Inspect  bearing  for  damage  and  binding,  Replace  if damaged   or   binding.   Discard   seal.   If   damaged,   remove   bearing   cup   (12)   and   retainer   (11). 7 . Inspect  all  grease  fittings  and  replace  if  damaged. b. ASSEMBLY NOTE l  On   left   side,   steering   arm   is   installed   to   steering   knuckle   (8)   with   4 nuts.   On   right   side,   upper   kingpin   bearing   cap   is   installed   to   steering knuckle   with   4   bolts   and   Iockwashers. l Left  side  assembly  is  given, • Seal   (14)   will   protrude   slightly   from   surface   of   axle   housing   (9)   flange when   installed. 1. If   removed,   assemble   retainer   (11)   and   bearing   cup   (12),   and   install   to   axle   housing   (9) flange.  Fill  area  in  retainer  with  grease.  Grease  bearing  (13)  and  install,  Install  new  seal  (14). TA60565 6-74

 

 

Please feel free to link to this site so that others can find it.  It's easy to link to this site, just copy one of the texts below onto your web page:

 

 

Zen's Bronco

 

 

 

 

Copyright © 2000-2005