Back
8-3. FRONT  LOCKING  HUB  REPLACEMENT		 Up
Axles		 Next
8-4. ROTOR AND WHEEL BEARINGS MAINTENANCE (Con’t)
TM   9-2320-289-20 8-4. ROTOR    AND    WHEEL    BEARINGS    MAINTENANCE. This   task   cowers: a.    Removal c.   Installation b.   Cleaning   and   Inspection INITIAL  SETUP: Equipment     Condition Materials/Parts Caliper   removed.   (See   paragraph   7-11) • Front   locking   hub   removed. • (See   paragraph   8-3) • • • • #4-40   Screw One   seal Six   Iockwashers   (all   except   M1009) Six  locknuts  (Ml  009) Dry   cleaning   solvent (Item   15,   Appendix   C) Grease   (Item   26,   Appendix   C) Tools/Test    Equipment Manual    References • • • • • • Annular   bearing   inserter,   J-23445-A • TM 9-2320-289-20P Nut   wrench,   J-26878-A   (all   except   M1009) Nut   wrench,   J-34616   (1984,   M1009   trucks) Hub   nut   wrench,   J-6893-D (1985-87,   M1009   trucks) Snapring    pliers Torque   wrench General/Safety Instructions •   Dry   cleaning   solvent   is   flammable   and   must   not   be   used   near   an   open   flame.   Use   only   in   a well-ventilated   area. •   DO   NOT   use   a   dry   brush   or   compressed   air   to   clean   brake   pads   or   brake   components. NOTE •   If   removing   rotor,   wheel   bearings,   and   caliper   bracket   from   all   except RA1009,   perform   steps   1,   4,   and   5. •    If    removing    rotor,    wheel    bearings,    and    caliper    bracket    from    M1009, perform   steps   2-4,   and   6. Change   2 8-5

 

 

Please feel free to link to this site so that others can find it.  It's easy to link to this site, just copy one of the texts below onto your web page:

 

 

Zen's Bronco

 

 

 

 

Copyright © 2000-2005